chickadee-3d-design
Spin & Draw Marker Top Set
Spin & Draw Marker Top Set
💛 Design example only
📩 Message us on Facebook or email to order (Ordering Info)
Couldn't load pickup availability
Pick a colour, pull the strip and watch your marker draw as it spins! 🎨
The Spin & Draw Marker Top turns a blank page into loops, swirls and colourful trails. Try overlapping two colours or starting your spins in different spots to see what patterns you can make.
What’s included
- 1 spinning marker top
- 1 launcher and pull strip
- 1 Crayola Ultra-Clean Washable Marker in a randomly selected colour
Want to try another colour? You can swap in any other colour from the Crayola Ultra-Clean Washable Markers range. Additional markers are sold separately.
How to use
- Fit the marker into the top with the tip pointing down.
- Attach the top to the launcher and insert the pull strip.
- Hold it just above a large sheet of paper on a flat, protected surface.
- Pull the strip and watch it spin and draw!
3D-printed by Chickadee 3D Design in Halswell, Christchurch.
Contains small parts. Adult supervision recommended.
The spinner is a fan-made item and is not an official product. Chickadee 3D Design claims no ownership of the referenced intellectual property and is not affiliated with, sponsored by, or endorsed by Crayo
Share
Important Information
Important Information
IMPORTANT:
♥ This product is MADE TO ORDER. All of the cutters and stamps are printed to order, and we don’t have stock on hand. Please allow 2-5 business days, shipping time NOT included.
♥ Cutters' colours may be different from pictures.
Embossed or Debossed (Raised)
Embossed or Debossed (Raised)
DIFFERENCE BETWEEN EMBOSSED AND DEBOSSED:
♥ Cookie Embosser will leave an imprint into your fondant.
♥ Cookie Debosser (Raised) will provide a 3D pop-out design.
Size
Size
What is the size of the cutter?
- X-Small (65mm)
- Small (75 mm)
- Medium (90 mm)
- Large (100 mm)
- X-Large (120 mm)
These measurements are the longest dimensions of the cutter.
Cutter Dimensions:
- Cutter Handle Width 10mm
- Cutter Depth 15mm
Care Guide
Care Guide
We print our cutters on a 3D printer using a high-quality, food-safe PLA. The Cookie Cutter can start to soften and lose its shape from around 50 degree C.
Don't use a dishwasher due to the heat used. Hand wash only in warm water, using a soft brush as required for any small corners. Putting the cutters in a dishwasher could melt, warp, or otherwise damage the PLA.
Essential Tips
Essential Tips
♥ For easy release of dough, remember to coat the stamp with icing sugar/ flour before imprint
♥ Cookie cutters suitable for fondant, cookie dough, clay, biscuit dough etc.
♥ where a cookie embosser will leave an imprint into your fondant, the debosser will provide a 3D pop-out design.
